Royal Sovereign Laminator PL 922 User Guide

Royal Sovereign Laminator  
OWNER'S MANUAL  
PL - 922 /1302  
Read all instructions carefully before use.  
Royal Sovereign Int'l Inc.  
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500  
 
1
CHARACTERISTICS OF PL-SERIES  
1. Hot Laminating Function  
PL-Series are ideal for laminating all types of photos, documents,  
digital prints and glossy papers without carrier  
2. Cold Laminating Function  
The cold function is perfect for heat sensitive prints.  
3. Temperature Fuse  
A temperature fuse in a PL-Series makes more safe.  
4. Autoreverse Function  
When films are jammed at a roller, PL-Series perfectly solve it by  
automatic reverse function with convenience.  
SAFETY PRECAUTIONS  
The safety precautions outlined in this section are to be read and  
followed before operating machines. Keep this information for  
future reference. Failure to comply with any of the following safety  
procedures could result inserious injury.  
1. To prevent the possibility of electrical shock, do not immerse machine  
in water or permit liquids to get inside.  
2. To prevent the possibility of fire, do not allow articles of clothing  
(neckties, scarves, paper etc.) to get inside.  
3. Do not insert sharp objects (pin, clip, coin etc.) into front or rear openings  
of the machine.  
4. Do not attempt to laminate items that exceed total recommended  
material thickness.  
5. Do not operate machines for any other purpose other than its intended use.  
6. Turn off the power when unattended or not in use. Unplug machine before  
moving or when it is not in use for an extended period of time.  
7. This machine is intended for indoor use only.  
8. During an operation, a machine has high heat. Keep children away  
from the machine.  
9. That the socket-outletshall be Installed near the equipment and  
shall be easlly accessible.  
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500  
 
3
OPERATING CAUTIONS  
1. Do not laminate a pouch film only without an item. Do not use unsealed  
pouch film. (It causes jams)  
2. When a material is reversing, lightly pull the material by a hand in order to  
avoid jamming on the roller again.  
3. Using a small pouch, put the film into the middle area (Sensor area)  
of the machine. (There is only one sensor in the middle area of a machine.)  
4. Putting an item to be laminated into a film, drive the item to a sealing  
part of the film. (It prevents anti-jam system from not-running.)  
5. When you start to laminate, put the material immediately.  
(If you touch a front sensor more than 3 seconds, it could operates  
anti-jam system. During operating a anti-jam system, rollers reversely  
rotates and you can't laminate.)  
6. Anti-jam system operates during 15seconds. Please, try laminating  
after 15seconds.  
7. When a laminated material is hot, it can be easily bent or deformed.  
Cool a laminated material on a flat surface  
8. Thanks to Auto Reverse Jam Free function in this machine, jam shall be  
solved automatically.  
Meanwhile, since the function is controlled by optical sensor, so it may  
cause malfunction when operated in direct sunshine.  
HOW TO USE CLEANING PAPER  
1. Turn on the machine, after READY light illuminated, remove dirt stuck  
on a roller by passing a Cleaning Paper through a machine once or twice.  
2. If the outside of a Cleaning Paper is getting dirty, use the inside folding  
upside down. If you use the inside, the outside become stuck and  
cannot use. Therefore, after full using the outside, use the inside.)  
3. If a Cleaning paper is spoiled or you can not use both-sides of a Cleaning  
Paper, get a new white coated paper at the nearest stationery shop and  
use it.  
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500  
 
4
OPERATING INSTRUCTION  
1. Place and use a laminator on a sturdy, flat work surface.  
2. Plug the laminator into a power source that matches the laminator's  
rate of voltage.  
3. Turn the temperature control switch to 'COLD' position.  
4. Press the power switch to 'RUN' position. (Please refer to Figure 'Power  
Switch.) (Red 'POWER' light will illuminate and a motor starts to operate.)  
5. Set the temperature control switch to a right position that matches the  
thickness of your film.  
6. Wait for a 'READY' light on.  
7. After 'READY' light is on, put a material into a front opeening.  
(Before laminating, do not let the material stay over 3 seconds at the front  
opening. It could causes a anti-jam system's wrong operation.)  
8. After a finished laminated item is completely fed out through the rear of the  
laminator, insert another pouch into the front opening.  
9. When cold laminating, turn the temperature control switch to 'COLD'  
position. Be sure to confirm if the 'READY' light is completely lighted.  
10. When a material is jammed at a roller, it will be automatically reversed.  
And the jammed material will be automatically discharged. However, if you  
want to reverse at any occasion, you can press the switch to REV.  
mode and then remove the material by manual.  
Temperature control switch  
Power switch  
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500  
 
5
SPECIFICATION  
Description  
PL-922  
PL-1302  
Dimension(W*D*H)  
Max.Laminating Width(mm)  
Max.Laminating Thickness(mm)  
Number of Rollers(EA)  
Heat Source  
405×205×122  
530×205×122  
235  
250  
340  
175  
4
HOT SHOE  
4 Min  
Pre-heating Time  
Motor Type  
AC MOTOR  
520  
Laminating speed(mm/min)  
Weight(Kg)  
3.8  
5.5  
Voltage/Cycle  
AC 100V. 120V. 220~240V. 50/60Hz  
550 890  
Power Consumption(W)  
TROUBLE SHOOTING  
Symptom  
Check Point  
1. Check if the power cord is plugged in.  
2. Check if the switch is on.  
Motor doesn't work.  
Hot laminating function  
doesn't work.  
1. Check if the temperature control switch  
is set to the hot laminating position.  
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500  
 
6

Radio Shack Karaoke Machine 32 1167 User Guide
RayTek Thermometer MX Series User Guide
Rival Slow Cooker Smart SetTM User Guide
Ryobi Blower 290r 2 User Guide
Samson Home Theater System SXD3000 User Guide
Samsung Projector BP59 00143A 04 User Guide
Samsung Tablet GTP3100TSLTTT User Guide
Samsung TV VCR Combo CXM1974 User Guide
Scotsman Ice Ice Maker CU3030 User Guide
Sears Lawn Mower 24738824 User Guide