Ultra mobile USB
Spinpoint N2B
Capacity
Model
120GB
HS120JR
FEATURES
• MAX.80GB Formatted Capacity Per Disk
• Bus Power Usage
• High Speed Digital Signal Processor Based Architecture
• ATA S.M.A.R.T Compliant
• Compatible MAC OS higher
• Support Plug and Play
• ATA 28-bit Address Feature Set
• Multi-Burst On-The-Fly Error Correction
• SilentSeek™
• Host Swappable
• Direct Bootable under Windows 2000 version up
• Free Fall Sensor (optional)
DRIVE CONFIGURATION
Capacity
ENVIRONMENTAL SPECIFICATIONS
Temperature
120 GB
USB 2.0
Interface
Operating
5 ~ 60 ℃
Rotational Speed
Buffer DRAM Size
Byte per Sector
4200 RPM class
2 MB
Non-operating
-40 ~ 85 ℃
Humidity (non-condensing)
Operating
512
8 ~ 90 ％
PERFORMANCE SPECIFICATION
Average Seek time (typical)
Average Latency
Linear Shock (1/2 sine pulse)
Operating, 2ms
Non-operating, 1ms
Vibration
15.0 ms
8.3 ms
600 G
1500 G
Media Transfer Rate (Max.)
Interface Transfer Rate (Max.)
USB 2.0
458 Mb/s
Operating
0.67 Grms
480 Mb/s
3.0 sec
Altitude (relative to sea level)
Operating
Drive Ready Time (typical)
-300 to 3.000 m
-400 to 15,000 m
Non-operating
RELIABILITY SPECIFICATION
Non-recoverable Read Error
Controlled Ramp Load/Unload
1 sector in 10^13 bits
600,000
PHYSICAL DIMENSION
Height
8.0 mm
71.0 mm
54.0 mm
59 g
Width
ACOUSTICS
Idle
Length
1.8 Bel
2.4 Bel
Weight (Max.)
Performance Seek
POWER REQUIREMENTS
Voltage
+5V ±5%
350 mA
1.10 W
1.20 W
0.45 W
0.25 W
0.25 W
Spin-up Current (Max.)
Seek (typical)
Read/Write (typical)
Idle (typical)
Standby (typical)
Sleep (typical)
* Note : Design and specifications are subject to change without prior notice.
1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
* Accessible capacity may vary as some OS uses binary numbering system for
reported capacity.
* A small portion of the (2MB) buffer memory is reserved for firmware use.
1.8" HDD USB product specification Rev.06
Match with USB product manual Rev 01
|