DO-IT-YOURSELF
INSTALLATION INSTRUCTIONS
LEVEL MONITOR SYSTEM
Your TankWatch Level Monitor System contains these items:
The TankWatch Level Monitor System is
designed to operate on 12 VDC in a sewage
holding tank, and to signal a nearly full tank
condition. This instrument will give years of
reliable service if installed properly.
HOW IT WORKS...
SWITCH ASSEMBLY
INDICATOR
ASSEMBLY
Plenty of capacity...
all is well.
Red light glows...
nearly full.
2-No. 4x1/2”
MOUNTING SCREWS
4-No. 8x3/4”
GASKET
MOUNTING SCREWS
CAUTION! DO NOT USE IN FUEL TANK!
Select a location as far as possible away from other
tank fittings. Drill 1 1/4-in. (32mm) dia. hole (hole
saw is best) in tank TOP.
NOTE FOR SAILBOATS: Locate switch on
athwartships centerline of tank to assure accuracy
when heeled.
Locate Switch Assembly into the 1 1/4-in. hole
using care to stay on center. Mark four mounting
holes. Remove SwitchAssembly.
1
2
Drill mounting holes using 1/8-in.
(3mm) dia. drill bit. DO NOT mount
SwitchAssembly at this time.
Select a location for your IndicatorAssembly. Drill
a 1-in. (25mm) dia. hole to accommodate the LED
wires.
4
3
MOUNTING TEMPLATE FOR
TANKWATCH PANEL
Drill 1-in.
(25mm) hole
|
Q See Home Security System QS218 811 User Guide
Radio Shack Caller ID Box CID 927 User Guide
Remington Power Tools Trimmer BGS36A User Guide
Renesas Network Card M306H2T RPD E User Guide
Renesas Network Card PCA7400 User Guide
ResMed Nebulizer 608133 1 User Guide
Royal Sovereign Laminator 1650C User Guide
Saitek Mouse Notebook Laser Mouse User Guide
Samsung DVD VCR Combo DVD V3300 User Guide
Schumacher Battery Charger 00 99 000942 User Guide